Model: Add-on 1-Section Center Unit Kit Only
Steel Specs: 3.5" OD Round Tubing / Schedule-40 / Galvanized
Steel
Used with: 2-section
Commercial Frame Kit
Overview: Our 1-section add-on kits are available to combine
with our 2-section Commercial Frame Kits, which will extend your available cage
length. Instead of only placing 1 section on each end, an additional center
section supports the cable lines in the middle. The cable lines pass through
an inverted eye-bolt installed on the cross-member of the center unit, which
relieves some tension on the lines, allowing them to more adequately support
the ceiling of the net; reducing sag. The center unit is specifically designed
to be wider & taller than the end sections, which allows plenty of room
for net stretch to avoid ball ricochet, and also peaks the ceiling.
Add an indefinite number of 1-section center units for whatever cage length
you need!
Highlights:
- Minimizes number of ground holes
- Accommodates nets up to 16'H
- Very clean & pro appearance (less # of obtrusive frame poles - net maintains
clean look with cable system)
- Frame galvanized weather-proof (other colors available for cost)
Standard Parts:
- (3) Galvanized Steel Poles -- 19'6"L each (can be cut)*
- (2) Elbow Corner Brackets
- (3) Eye-bolts: 4" x 5/8" with washer & 2 nuts
- *Poles can be cut to fit your specific net size if requested, for up-charge
- however, it's recommended to leave this unit with longer poles to reduce
ball ricochet & peak the center - if your space allows.
- *Poles should be inserted minimum of 2' Deep x 24" Diameter, depending
on your soil conditions & freeze-line
- *Custom colors available for up-charge
- *Ground Sleeves NOT included - can be acquired at your local hardware /
plumbing store if needed
Net sizes to use with this system listed at bottom. Also find
custom
sized prices here.
*If custom pole size required, select "Custom Pole Cuts" in options
above, and specify your net size in "comments" during check-out. If
not specified, frame sections will ship per the lengths listed in parts list.
*Poles should be inserted minimum of 2' Deep x 24" Diameter, depending
on your soil conditions & freeze-line.
*Recommended total pole spacing: 5' longer than your net length & same
width as net
